Question: When the driver starts, it sets the computer’s TimeStamp for each read value, instead of the remote unit’s TimeStamp. How can I fix this issue, or at least discard…
Question: The addressing format in the device is AI:3000019, but the tag’s N3 parameter only supports values no bigger than 65535. How can I fix this? Solution: BACnet protocol supports…
Question: Do IEC and DNP drivers work in full-duplex and half-duplex mode? Solution: Yes. Elipse’s IEC and DNP drivers support both full-duplex and half-duplex modes. The operation mode must be…
Question: Is it possible to read data Int16? Solution: Yes, it is. To do so, use function 15 on the PLC tag’s N2.
Question: When using Atos APR03 driver, what do the N parameters in a PLC tag mean? Solution: The meaning of each one of these parameter is as follows: N1 –…
Question: Which driver communicates with Atos PMC 4004R PLC? Solution: To establish communication with this PLC, use Atos APR03 driver. This driver allows communication with the following devices: MPC1200, MPC1600,…
Question: Which driver is compatible with ELO2113 meter? Solution: To read the user’s outputs, use ABNT NBR14522_SU driver. To read mass memory, use ABNT NBR14522 driver.
1) Introduction Due to a great number of devices whose communication occurs via ASCII protocols, Elipse Software has developed the ASCII Generic Driver. This driver is used to establish a…
Question: How can I establish communication between Micrologix PLC and Elipse E3? Solution: To do so, use Allen-Bradley ABDF1 driver, and perform one of the following settings: Use DF1 protocol…
Question: Which driver is used to establish communication with an Altus Piccolo 106 PLC? Solution: This PLC uses Altus ALNET I driver (Alnet 1v2 driver). However, if an ethernet module…