Question: How can communication between Elipse E3 and the microcontroller from Arduino platform be established? Solution: To establish this communication, we will use Modicon Modbus Master (ASC/RTU/TCP) driver, available for…
1) Introduction In addition to communicating with APR03 protocol, ATOS’s controllers can also establish communication with Modbus protocol (which can be set at ATOS’s programming tool) on RTU mode via…
Question: How many driver licenses are needed to establish communication with 35 remote units? Solution: There are two possibilities, depending on the Modbus network’s architecture: If all 35 RTUs belong…
Question: Can several PLCs with communication RS485 be connected to a Serial/Ethernet converter when they are using a Modbus driver? Solution: Yes, this is possible. In this case, the Modbus…
Question: Can data be collected from a SCADA application and sent to a master device via Modbus protocol? Solution: Yes, it can. To do so, you must add a slave…
Question: Is there any driver to be used specifically with Ciber Circuitor NRG-96 meter? If not, what protocol can be used to establish communication? Solution: Elipse Software has not developed…
Question: How can I configure an I/O Tag to read a Modbus 40001 address? Solution: To do so, after you have configured the communication physical layer, follow these procedures in…
Question: How can I configure the driver to read a float-type variable from a Kron’s multimeter? Solution: Go Modbus tab on driver settings, and check the options Swap Byte and…
Question: Can I use a Modbus driver with several PLCs on a RS485 network? Solution: Yes, you can. Each device must have a Modbus address on this network. At each…
Question: On a Modbus network, can there be more than one master accessing a slave driver? Solution: No, the Slave Driver does not accept more than one master by accessing…