KB-36059: Executing a double-point command via DNP driver.
Question: Which object and variation must be used for a double-point command via DNP driver? Solution: In a DNP driver, you must use an Object 12, and Variation 1 –…
Question: Which object and variation must be used for a double-point command via DNP driver? Solution: In a DNP driver, you must use an Object 12, and Variation 1 –…
Question: Is it possible to read digital inputs (SOE) with a Block Tag via DNP driver? Solution: No, this is not possible, because all elements in the block share the…
Question: Can Enable Unsolicited on Startup and Scans for Events every X ms options on DNP Master driver’s work together? Solution: Yes, they can. However, since you may want to…
Question: I am not being able to establish communication in E3 between DNP Master and Slave drivers when executing the master application. In the slave machine, there are two open…
Question: Can I configure a pulse’s duration in a DNP driver? Solution: Yes, you can. Driver’s Extra Settings’ DNP tab brings the options Control Relay Off Time – ms an…
Question: What settings are used to issue commands via a DNP Master driver? Solution: Use the following settings in an IOTag: N1 = 1, N2 = 5, N3 = 1201,…
Question: The addressing format in the device is AI:3000019, but the tag’s N3 parameter only supports values no bigger than 65535. How can I fix this? Solution: BACnet protocol supports…
Question: Do IEC and DNP drivers work in full-duplex and half-duplex mode? Solution: Yes. Elipse’s IEC and DNP drivers support both full-duplex and half-duplex modes. The operation mode must be…
Question: Which driver communicates with Atos PMC 4004R PLC? Solution: To establish communication with this PLC, use Atos APR03 driver. This driver allows communication with the following devices: MPC1200, MPC1600,…
Question: Is it possible to read data Int16? Solution: Yes, it is. To do so, use function 15 on the PLC tag’s N2.